Before you begin heating with a toaster, you have different instruments and voices. This article describes what is needed for the process, including an amendment to be done in the oven, various tools and a description of how a vacuum picker at low cost.
The first element is the toaster. You can use any type of toasters, but in general I do not recommend young people. Midsize companies seem to work best. Whatever you may need a glass door inbefore, so you can see what is happening inside the oven without opening the door.
You also need a digital thermometer and a thermocouple. You can buy these at your local electronics store.
The thermocouple is like a long wire with a plug at the end. The connector end plugs into digital thermometer outside the oven, and the other end goes around the edge of the oven door and oven.
It 'also importanthave a timer, so you can check the weather changed and the temperature in the oven.
You need the following change to your toaster oven to toast their views not by infrared radiation heating elements directly.
The aim is that the heating elements, only the air in the heat of the oven, so that a direct line of infrared heating elements of the circuit should be avoided.
The way to do this is to do someAluminum foil and a cut, so that it covers only up to the elements. You can use a disposable baking tray in the supermarket, make this layer of aluminum.
The aluminum foil can be connected to push through an oven to weave into the pan. This will remain in force.
Place one of these aluminum sheets for both top and bottom heating elements of the oven.
The next item is the solder paste gun. This is the easiest way to apply the pads smalladheres to the surface mounting pads of chip components.
I use lead solder AIM, but all the base solder paste suitable for this process. You can use a soldering iron and solder paste from your service provider dedicated team of local welding. I bought these items in electronic solutions here in Australia.
Now we'll see how to make a collection of vacuum pump air tools, small aquarium, you can get for ten dollars at your local store or aquariumPet Shop. I describe how I made the changes.
When I removed the air pump, so you can enter the air intake hole of the pump. Then I just get a plastic mouthpiece that I made a dosing syringe. Attached is a short distance of 3 mm air hose, vinyl I have in store aquarium. Then, another metal nozzle, which came from a donor other than the syringe.
Injectors can your local team of welding expertsProvider. The nozzles in general, are syringe with some games, but may also be able to purchase separately.
To use this tool, vacuum low-cost but effective set of easy on the pump and put the nozzle down on the chip component. The component will be drawn and held at the end of the nozzle. dotted Then place the component on the chip pads of the PCB, solder paste. Place the component down. The solder paste is very stickyto pack the unit and hold it. There is no need for vacuum release.
It includes all the elements that welding with a toaster in need, including a change in the furnace, various tools, and a description of how to make a low-cost vacuum pickup tool.
No comments:
Post a Comment